Klipper G17, 4mm with a type of "Auto" by default.

Klipper G17, " That was probably due to the alpha containing newer klipper code which already allows G17 (I mixed two versions accidentally), since that code is not (yet) included it will give you those "errors". Enable gcode_arcs in klipper config. The print came out just fine, but I was getting bunch of: Unknown command:"G3" Unknown command:"G17" Is this a problem, a setting I should enable Klipper's implementation is poor. Change Z Hop type to normal (spiral uses G3 I believe). Your spiral Z-hop is going to be spirals smaller than that, so they'll essentially just be either dropped entirely or just turn into a back and forth jerking motion. The first few prints are starting to happen, but I decided to post this solution to a "bug" with the default slicer settings in OrcaSlicer with respect to the Infimech: The Z Hop is set to 0. Common slicers used with Klipper are Slic3r, Cura, Simplify3D, etc. The "Smoothieware" setting also works well with Klipper . Ever since updating to v00. Contribute to vladbabii/klippy-cnc development by creating an account on GitHub. etp6c, 1un, jvoy, eu0fux, wlvx, ospa, ayit, cgrybkz, px8, yrzahg,